The Girl, our virtual hostess for your 4D comfort waterbed
logos
Home |  Support |  Installation of a waterbed | 

A. The plinth

(A standard plinth is used for this example. Other plinths are available with drawers or built-in safe)

Place the first part of the plinth at the head end where you want it to be 01a Keep in mind that the edge of the bed will stick out about 10cm, so it is best to leave some space between the edge of the bed and the wall.Place the parts of the plinth so the corner profiles cover the outer edges of the board (01a) 01

01. Place the first part of the plinth at the head end where you want it to be. Keep in mind that the edge of the bed will stick out about 10cm, so it is best to leave some space between the edge of the bed and the wall. Place the parts of the plinth so the corner profiles cover the outer edges of the board (01a)

Connect the plinth elements to the corner profiles. Make sure that the angle between 2 parts is always 90°. 02
02. Connect the plinth elements to the corner profiles. Make sure that the angle between 2 parts is always 90°.
Do this for all 4 parts of the plinth creating a perfect rectangular plinth.03
03. Do this for all 4 parts of the plinth, creating a perfect rectangular plinth.
Assemble the nine supports by sliding the 2 parts together 04
04. Assemble the nine supports by sliding the 2 parts together.
Position the nine supports inside the plinth 05
05. Position the nine supports inside the plinth.
Make sure the 8 outer supports are positioned against the inner sides of the plinth and the ninth precisely in the middle 06
06. Make sure the 8 outer supports are positioned against the inner sides of the plinth and that the ninth is placed precisely in the middle.

Part B.  the baseboard