K. Filling the watercontainer.
51. Before you start filling the Dual system you will need
a T-connection to fill both mattresses at the same time.
 52
52. Connect the hoses that you will be using to the tap.
Rinse the inside of the hose and remove all the dirt inside by letting the water run for a minute.
If you notice any traces of algae deposits, DO NOT USE this hose to fill your water mattress.
Insert the hose at least 30 inside the mattress or use the adapter to screw the hose onto the pull
cap.
 53
53. Fill the mattress with clean tapwater up to 30°C. Do
NOT use water from a well, rainwater or any other surface-type water. In some cases a boiler will
not be sufficient to fill the whole bed with warm water, the waterbed heater will warm up the rest
of the water.
 54
54. Fill the mattress until the water level reaches 1 cm
underneath the top of the foamrail. you can verify the waterlevel by turning off the tap and having
a look at the water level through the transparent pull cap. If necessary you can use a long
straight object to compare both edges with the level inside the pull cap.(54a)
|
